This is a 3 bar pressure sensor, and should only be used on Neon SRT-4's and PT Turbo's running over 22-23+ psi of boost with a custom tune, or Mopar stage 3 turbo kit. If these sensors are installed on a SRT-4/PT without the custom tune, or stage 3 ecu, the car will not run correctly and will run rich, and lose a lot of horsepower.

You should not purchase this sensor unless:

1) You already have our 3 bar pressure sensor kits, and need a replacement sensor.
2) You are doing a custom install on another platform (ie, supercharged/turbocharged Challenger, Charger, Hemi, etc. 

With all that being said, if you have a Neon SRT-4 or PT Turbo and need a complete 3 bar map and tip sensor kit, please see our complete kits with brackets and adapters so that you'll be able to install them correctly.

For this product, we offered Mopar 3 bar pressure sensors for many years, until the Coronavirus pandemic hit and Mopar started having serious supply problems. Then in mid 2024, Mopar discontinued the 3 bar map sensor. So we started to look at other options. We evaluated and tested map sensors from 5 different suppliers. We found that some would have problems separating the casing at higher boost levels, and some had electronic connector keyways cast for the case that were incorrect, making it difficult to connect the plug.

This one sensor we are selling now, had correct voltage output, tested perfect up to 40 psi of boost, and the connector was perfect. We have total faith in this aftermarket sensor, and so if you need a replacement, this is a good sensor to go with.

Works on:

• 2003-2005 Dodge SRT-4
• 2003-2010 Chrysler PT Turbo