When you're fastening into concrete, block, or masonry, the Dagger-Con screw isn’t just up for the job - it was made for it. Designed with a sharp point and hi-low threads, these screws cut clean into hard materials and hold tight without spinning out. They're quick to install and built to last, whether you're anchoring indoors or outdoors.

The flat, countersunk head sits flush for a smooth, professional look - ideal when you're going for function and finish. And the blue Dagger Guard Coating isn’t just eye-catching. It's a high-performance, corrosion-resistant layer that protects your fastener in tough environments and tough jobsites.

If you're mounting hardware, hanging conduit, or driving into CMU, these screws are the kind of small part that makes a big difference.

Key Features:

• Hi-Low Thread Design: Improves bite into concrete and block, delivering strong grip and reducing installation torque.
• Sharp Point: Eliminates the need for pre-drilling in many applications.
• Blue Dagger Guard Coating: Durable corrosion resistance for long-lasting performance, indoors or out.
• Countersunk Flat Head: Allows for flush installations, keeping surfaces clean and snag-free.
• Phillips Drive: Installs easily with a standard Phillips driver - no specialty tools required.

Applications:

• Mounting hardware or electrical boxes to concrete or masonry
• Anchoring fixtures, hangers, or track to block walls or poured concrete
• Indoor or outdoor installs where rust-resistance and clean finish are important
• General construction, electrical, and low-voltage systems that need secure, permanent fastening to hard base materials

Installation Tips:

1. Use a hammer drill with a carbide bit for pre-drilling when needed—especially for dense or older concrete.
2. Match the pilot hole to the diameter and embedment depth of the screw to avoid cracking or over-tightening.
3. Drive the screw until flush; avoid overdriving to protect the base material and keep the head seated cleanly.