Bulldog Trailer Trailer Tongue Jack 4000LBThe drop leg has a spring-loaded pull pin for quick release.3 LED lights allow easy setup at night. Built-in level included. Surfaces are sealed, maintenance-free, and corrosion resistant.Features:

• Tongue jack positions quickly and easily with integrated drop leg
• Powered drive provides quiet operation and efficient use of electrical power
• No more hand cranking
• Spring-loaded pull pin quickly releases the drop leg into position
• Built-in level has springs for simple, accurate leveling
• 3 LED lights make it easy to set up at night
• Side-mounted spot lights are angled rearward to illuminate weight distribution brackets
• 4" - 6" Overlap of tubes at full extension provides additional support for side loading
• Easy-to-access on/off and retract/extend toggle switches make for simple operation
• Corrosion-resistant, sealed, maintenance-free surfaces
• Easily accessible emergency manual override in case of power loss
• Black housing with sleek design protects motor
• Positions quickly with 22" of total travel
• 4000 lbs. lift capacity
• Integrated gearbox and motor
• Drop leg
• Deploys and hookss up easily at night with onboard LED courtesy light, angled to illuminate coupler
• Works in case of power loss with emergency manual override capability, easily accessible from the top, crank included
• Lasts for years with industry-leading BULLDOG performance, known worldwide for unmatched strength, durability, and side load capacity
• Retains like-new appearance with corrosion-resistant surfaces

• Bracket height:
• 9-3/4" Retracted
• 31-3/4" Extended
• Total travel: 22"
• Lift: 14"
• Drop leg travel: 8"
• Inner tube diameter: 2"
• Outer tube diameter: 2-1/4"
• Lift capacity: 4,000 lbs

Instructions:1. Attach trailer to tow vehicle. Use vehicle’s parking brake and chock wheels of trailer.2. The Powered A-Frame Jack has been designed to attach to the top surface of the A-frame coupler.3. Disconnect the trailer battery ground cable.4. Detach the drop leg of the jack by removing the lynch pin.5. Position the drop leg beneath the coupler mounting hole with the foot of the drop leg on the ground.6. Place the jack outer tube through the A-frame coupler hole and over the drop leg. The dual mountingpattern allows positioning of the jack either facing the tow vehicle or for side operation.7. If the Plunger Pin kit is included with this jack, install per instructions below, then continue on to #8.8. Attach the jack using the three (3) 3/8†diameter, 1†long, grade 5 bolts and nuts (provided). Use theprovided lock washers, placing them between the bolt head and the top of the jack mounting bracket.Star washers are used to insure a metal-to-metal contact between jack and coupler for proper grounding(Figure 1). Torque bolts to 15-20 ft-lbs.9. Route the black wire lead from the plastic cover along the trailer to the battery. Attach the wire leadto the trailer using cable ties or equivalent.10. Connect the wire lead from the jack directly to the positive (+) terminal of the battery. This unit hasa built-in circuit breaker which automatically trips and resets. Reconnect the battery ground cable.11. Check for proper installation by pressing the motor switch that is marked “EXT†for extending thejack and “RET†for retracting the jack. Also check that the light switch turns on the LED light locatedunder the top cover of the jack.12. After checking for proper operation, be sure to reattach the drop leg to the inner tube of the jack usingthe lynch pin or plunger pin assembly.13. Retract the jack completely.Installation Instructions:http://media.viantp.com/PMDT/BDG/InstallationInstructions/500199.pdf