Need a dependable R134a compressor for low to medium temp gear? The Embraco Aspera FFI10HAK is a hermetic reciprocating compressor built for Low–Medium Back Pressure (L/MBP) work on 220–230V, single-phase systems. It’s a solid pick for cabinet change-outs where you want stable pull-down and fewer call-backs.

Features & Benefits

• R134a, L/MBP application – designed for low to medium back-pressure refrigeration duties (typical cabinet and light commercial work).
• Australian-friendly power – 220–230V, 50–60Hz, 1~ for straightforward installs on AU mains.
• 1/3 HP (FF series platform) – a common size for many display fridges, merchandisers and similar equipment.
• 9.04 cm³ displacement – proven sizing for steady performance in cabinet refrigeration.
• POE (ester) ISO 22 oil charge – factory oil charge (~280 mL). Keep it clean and dry during install.
• RSIR/CSIR motor (LST) – low starting torque platform; start components must be matched to the unit nameplate/spec.

Who This Is For

This compressor suits licensed refrigeration techs doing replacements on R134a systems like display fridges, merchandisers, vending and similar cabinet setups. If you’re swapping like-for-like and want a known platform, the FFI10HAK is a tidy option.

How to Install / Use (Tradie Checklist)

1. Confirm the match: refrigerant (R134a), application (L/MBP), voltage and mounting/pipe layout.
2. Recover refrigerant properly (don’t vent), isolate power, and make the site safe.
3. Replace the filter drier and keep the system sealed as much as possible (POE oil hates moisture).
4. Nitrogen purge while brazing to reduce scale, then pressure test and leak check.
5. Evacuate properly: pull a deep vacuum with a micron gauge, confirm decay/hold, then charge by weight.
6. Commission: verify airflow, condenser cleanliness, running amps, and cabinet temps after pull-down.

Important notes (avoid headaches)

• Start gear matters: RSIR/CSIR compressors rely on correct relay/overload and (where specified) capacitor values. Don’t “send it” with tired components.
• Not for hydrocarbon swaps: this model is specified for R134a. Don’t use it for R600a/R290 systems.
• Moisture control: POE is hygroscopic. Keep lines capped, minimise exposure time, and always replace the drier.

Specifications

What’s Included

• 1 × Embraco Aspera compressor FFI10HAK
• Factory oil charge (as supplied)

Shipping & Returns

See our Shipping & Returns page for delivery timeframes and return steps. If your job is urgent, reach out via Contact Us and we’ll help with options.

FAQs

Is FFI10HAK suitable for R600a or R290?
No. This model is specified for R134a systems only.

Do I need to change the relay/overload and capacitor?
Strongly recommended. Correct start components are cheap insurance against nuisance trips and early failure.

Capillary tube or TXV?
Commonly used on cap tube cabinet systems. Always match the original design and confirm performance after pull-down.

Why Buy From HVAC Shop

• Australian owned & operated – learn more on our About Us page.
• Fast shipping Australia-wide (see timeframes on Shipping & Returns).
• Local support from people who understand refrigeration work.
• Secure checkout options for smooth purchasing.

Related Products

• Relay & Overload Combo – ideal to replace tired start gear during compressor swap-outs.
• Start Capacitors – handy when the original cap is weak or out of spec.
• Vacuum Pumps – pull a proper deep vacuum and keep moisture out of POE systems.