Do I need seam tape or gap filler between the kit panels and body?

It depends on your fitment. After test-fitting, inspect gaps between each panel and the body. If gaps are tight and even, a flexible sealant or adhesive-backed foam tape applied during final assembly will help seal seams and prevent water intrusion. Check fit before committing to permanent adhesive.

Can I paint each piece separately before installation?

Yes, painting panels off the car is often easier and gives you better coverage and finish quality. Sand, prime, and paint each piece in a controlled environment, then install once dry. This also lets you test fit and adjust mounting points before final color coat.

Will I lose jack point access with the side skirts installed?

Side skirts can obstruct factory jack points depending on your trim. Before final installation, verify that your vehicle's OEM jack points remain accessible. You may need to trim or notch the skirt panel slightly, or use a low-profile floor jack instead of the factory point.