Can I reuse the factory fog light bezels and sensor cutouts?

Yes. This bumper is designed around OEM hole placement. Before final installation, verify existing fog light and sensor openings align with the new cover, and drill or adjust as needed to match your setup.

Do I need to sand this before painting?

Yes. Sand the entire surface with appropriate grit to remove the Raw FRP finish and ensure paint adhesion. A clean, properly prepped surface is the foundation for a long-lasting finish.

Will this bumper interfere with a trailer hitch or rear sensors?

The bumper sits at factory depth. If you run a trailer hitch or parking sensors, measure the offset before ordering and confirm clearance with your installed accessories.